The Subaru Ascent is equipped with an advanced seatbelt system featuring Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR) mechanisms for enhanced safety. Under normal driving conditions, the system operates in ELR mode, allowing free movement while instantly locking during sudden braking or impact.
The ALR mode in the Subaru Ascent provides an additional function specifically designed for securing child restraint systems. When the seatbelt is fully extended and then slightly retracted, it locks into place and cannot be pulled out further. During this process, clicking sounds indicate that the system has switched to ALR mode.
Once the seatbelt is fully retracted, the Subaru Ascent system automatically returns to ELR mode, restoring normal operation.
When installing a child restraint system in the Subaru Ascent using the seatbelt, it is essential to switch the retractor to ALR mode to ensure proper and secure installation.
After removing the child restraint system, always allow the seatbelt to retract completely so the Subaru Ascent system returns to ELR mode.
For detailed procedures on switching between ALR and ELR modes, refer to the section "Installing child restraint systems with ALR/ELR seatbelt".
Seatbelt warning light and chime
Refer to the Subaru Ascent section "Seatbelt warning light and chime" for detailed information.
Passengers seatbelt reminder
Refer to the Subaru Ascent section "Rear passenger's seats" for additional guidance.
Related manual topics
Dtc p0107 manifold absolute pressure/barometric pressure sensor circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0107 MANIFOLD ABSOLUTE PRESSURE/BAROMETRIC PRESSURE SENSOR CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clea ...
Preparation for overhaul Procedure
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Preparation for OverhaulPROCEDURE1. Clean oil, grease, dirt and dust from the transmission.2. When transmission gear oil remains in the transmission, using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.3. Attach the drain ...
Dtc b1650 occupant detection system malfunction
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1650 OCCUPANT DETECTION SYSTEM MALFUNCTIONDiagnosis start condition:Ignition voltage is 8 V to 16 V.DTC detecting condition:• Occupant detection sensor is faulty.• Occupant detection ...