When the ignition switch of the Subaru Ascent is turned to the "ON" position, multiple warning and indicator lights illuminate briefly and then turn off. This built-in self-check confirms that the systems and indicator bulbs are functioning correctly.
To perform this system check, apply the parking brake and switch the ignition to the "ON" position. The following indicators will illuminate and then turn off after a few seconds or once the engine starts.
Seatbelt warning light (The seatbelt warning light turns off only when the driver
fastens the seatbelt.)
Front passenger's seatbelt warning light (The seatbelt warning light turns off only
when the front seat passenger fastens the seatbelt.)
Rear seatbelt warning light
SRS airbag system warning light
Front passenger's frontal airbag ON indicator light
Front passenger's frontal airbag OFF indicator light
CHECK ENGINE warning light/ Malfunction indicator light
Charge warning light
Oil pressure warning light
Low tire pressure warning light (U.S.- spec. models)
ABS warning light
Brake system warning light
Low fuel warning light
Power steering warning light
Vehicle Dynamics Control warning light/ Vehicle Dynamics Control operation indicator
light
Vehicle Dynamics Control OFF indicator light
Electronic parking brake indicator light
If any of these indicators fail to illuminate during startup in the Subaru Ascent, it may indicate a burned-out bulb or a malfunction in the corresponding system.
In such cases, it is strongly recommended to contact an authorized SUBARU dealer for inspection and repair to ensure continued safe operation of the Subaru Ascent.
Additional note: Regular monitoring of warning and indicator lights in your Subaru Ascent is essential for early detection of potential issues and helps maintain optimal vehicle safety and performance.
Related manual topics
Replacement of wiper blades
Contamination such as grease, wax residues, insects, or road debris on the windshield
or wiper blades of your Subaru Ascent can lead to uneven wiping, jerky motion, and
visible streaks across the glass. If these issues persist even after using the washer
system, thoroughly clean the windshield ...
BSD/RCTA
The Subaru Ascent BSD/RCTA system integrates advanced rear corner radar technology,
combining Blind Spot Detection and Rear Cross Traffic Alert to enhance driver awareness
in critical situations.
These intelligent safety features continuously monitor the rear and side zones
of the Subaru Asce ...