- Ignition switch (models without "keyless access with push-button start system")
- Push-button ignition switch (models with "keyless access with push-button start system")
- Hazard warning flasher
- Meters and gauges
- Illumination brightness control
- Warning and indicator lights
- Initial illumination for system check
- Seatbelt warning light and chime
- SRS airbag system warning light
- CHECK ENGINE warning light/Malfunction indicator light
- Brake system warning light
- Electronic parking brake indicator light
- Auto Vehicle Hold indicator light
- Vehicle Dynamics Control warning light/ Vehicle Dynamics Control operation indicator light
- Warning chimes and warning indicator of he keyless access with push-button start system
- Security indicator light
- Warning chimes and warning indicator of he keyless access with push-button start system
- Security indicator light
- Select lever/gear position indicator
- X-MODE indicator
- Combination meter display (color LCD)
- Center information display (CID)
- Clock
- Valet Mode
- Light control switch
- Steering Responsive Headlight (SRH)
- Headlight beam leveler
- Fog light switch
- Turn signal lever
- Wiper and washer
- Mirrors
- Inside mirror
- Smart Rearview Mirror/compass with HomeLink
- Brightness adjustment
- When the display mode malfunctions
- HomeLink Wireless Control System
- Outside mirrors
- Power folding mirror switch
- Defogger and deicer
- Tilt/telescopic steering wheel
Related manual topics
Reclining the seatback
Pull the reclining lever up and adjust the
seatback to the desired position. Then
release the lever and make sure the
seatback is securely locked into place.
The seatback placed in a reclined position
can spring back upward with force when
the lever is pulled. While operating the
lever ...
Adjustment
SECURITY AND LOCKS > Front Hood Lock AssemblyADJUSTMENT1. Loosen the bolt, and adjust the lock assembly - front hood while moving it up and down.2. After adjustment, tighten the bolts securely.Tightening torque:Refer to “COMPONENT” of “General Description”. General Descri ...
Installation
WIPER AND WASHER SYSTEMS > Rear Wiper ArmINSTALLATION1. Install in the reverse order of removal.2. Operate the rear wiper once.3. Align the blade assembly - rear wiper with the marking on the glass, and then tighten the nut to the specified torque.Tightening torque:8 N·m (0.82 kgf-m, 5.9 f ...