
The Subaru Ascent third-row seating area is designed to provide комфорт, практичність і безпеку для пасажирів навіть на задніх місцях. Proper seating position and correct use of safety systems are essential for maximizing protection in the Subaru Ascent.
WARNING
Seatbelts in the Subaru Ascent provide optimal protection only when passengers sit upright with their backs firmly against the seatback. Never place cushions or any additional objects between the passenger and the seat.
Incorrect seating posture may increase the risk of sliding under the lap belt or improper belt positioning across the abdomen, which can result in serious injury or fatal consequences during a collision.

WARNING
When loading cargo in the Subaru Ascent, never stack items higher than the top of the seatbacks. In case of sudden braking or impact, unsecured cargo may shift forward and pose a significant danger to passengers.
Third-row seats

To adjust the seatback in the Subaru Ascent, pull the strap upward and set the seatback to the desired angle. After adjustment, release the strap and confirm that the seatback is securely locked into position before driving.
Access to the third-row seats
The Subaru Ascent is equipped with convenient access levers located on both sides of the second-row seats. These levers allow easy entry to the third-row seating area.
WARNING
When the second-row seat in the Subaru Ascent is slid forward with the seatback tilted, it is not locked and may move freely. Never drive the vehicle or allow passengers to sit in this condition.
Failure to ensure proper locking of the seat may result in serious injury or even fatal consequences during sudden braking or collision.
CAUTION
When entering or exiting the third-row seats of the Subaru Ascent, make sure the second-row seat is fully slid forward and always watch your footing to avoid slipping or injury.
To access the third-row seat

Captain seat

Bench seat
Fold the second-row seatback forward and slide the seat toward the front to create sufficient space for accessing the third-row seats in the Subaru Ascent.
Before driving the Subaru Ascent, always return the second-row seat to its proper position, adjust it forward or backward as needed, and confirm that the seatback is securely locked.
To get out from the third-row seat

Captain seat

Bench seat
To exit the third-row seat in the Subaru Ascent, pull the release lever from the rear seating area.
The second-row seatback will automatically tilt forward and the seat will slide forward to allow easy exit.
Before driving, reposition the second-row seat and ensure it is fully locked and secure.
Related manual topics
Dtc u0402 invalid data received from tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0402 INVALID DATA RECEIVED FROM TCMReceived error data from TCM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Dtc p0172 system too rich bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0172 SYSTEM TOO RICH BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Improper idling• Engine stall• Poor driving performanceCAUT ...
Location
VEHICLE DYNAMICS CONTROL (VDC) > Relay and FuseLOCATIONMain fuse boxFuse 50A (VDC CM&H/U)(A)Fuse 30A (VDC CM&H/U)(B)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"> ...