In the Subaru Ascent, all doors, the rear gate, and the fuel filler lid can be automatically locked or unlocked based on specific driving conditions. This intelligent feature enhances both safety and convenience during everyday vehicle operation.
- For automatic door locking
- In the Subaru Ascent, all doors will automatically lock once the vehicle reaches a speed of approximately 12 mph (20 km/h), which is the factory default setting.
- Doors may also lock automatically when the select lever is shifted out of the "P" (Park) position.
- For automatic door unlocking
- All doors will unlock when the driver’s door is opened (default setting in the Subaru Ascent).
- When the ignition is switched to the "OFF" position, the system will automatically unlock the doors.
- Shifting the select lever back into the "P" position will also trigger automatic unlocking.
NOTE
- The automatic locking and unlocking settings in the Subaru Ascent can be customized via the center information display. Refer to the "Car settings" menu for configuration options.
- If the Subaru Ascent doors are locked manually using the power door locking switches, the automatic locking function will not activate.
- Similarly, manually unlocking the doors will disable the automatic unlocking function for that operation cycle.
- When exiting the Subaru Ascent through a rear door, always unlock all
doors using the power door unlocking switch. If a rear door is unlocked manually
and then opened and closed, the key lock-in prevention system may activate.
In such cases, all doors will automatically unlock, the warning indicator "
"
will appear, and an audible warning chime will sound. - In the event of a collision where the Subaru Ascent detects sufficient
impact force to deploy airbags, all doors will automatically unlock to assist
occupant exit and emergency response.
For more details, refer to "Automatic door locking/unlocking operation when involved in an accident".
Related manual topics
Tips for operating the audio/visual system
CAUTION
To avoid damage to the audio/visual
system:
Be careful not to spill beverages
over the audio/visual system.
Do not put anything other than an
appropriate disc into the disc
slot.
NOTE
The use of a cell phone inside or near
the vehicle may cause a noise from the
speakers o ...
Removal
BRAKE > Master CylinderREMOVALCAUTION:• Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.• Prepare a container to catch grease or oil, etc. If any grease or oil spills, wipe it off and cl ...
Installation
SEATS > Seat Heater SystemINSTALLATIONCAUTION:• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.• When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the ho ...