The Subaru Ascent BSD/RCTA system integrates advanced rear corner radar technology, combining Blind Spot Detection and Rear Cross Traffic Alert to enhance driver awareness in critical situations.
These intelligent safety features continuously monitor the rear and side zones of the Subaru Ascent, helping alert the driver to nearby vehicles when changing lanes or reversing. This significantly improves situational awareness in traffic and tight environments.
WARNING
The driver of the Subaru Ascent remains fully responsible for safe vehicle operation at all times. Always visually confirm surrounding conditions before changing lanes or reversing.
The BSD/RCTA system is designed as a support feature, assisting the driver by monitoring blind spots and rear cross traffic. However, it must never be relied upon as the sole source of safety confirmation. Overreliance on this system may result in delayed reactions to hazards and could lead to accidents causing serious injury or even death. Due to inherent system limitations, the BSD/RCTA approach indicator light or warning signals in the Subaru Ascent may not activate immediately, or may fail to activate in certain scenarios, even when another vehicle is present in adjacent lanes or approaching from the rear.
Always maintain full awareness of the rear and side surroundings when operating the Subaru Ascent.
- System features
- System operation
- BSD/RCTA approach indicator light/warning buzzer
- BSD/RCTA OFF indicator
- BSD/RCTA warning indicator
- Handling of radar sensors
Related manual topics
Dtc b1908 short in front p/t lh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1908 SHORT IN FRONT P/T LH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (LH) circuit is shorted to power supply.• Pretensioner (LH) is faulty.&bul ...
Installation
EXTERIOR/INTERIOR TRIM > Front BumperINSTALLATION1. Install each part in the reverse order of removal.2. Secure the flange section of the bumper face - front to the bracket - front bumper side.CAUTION:• Install so that the front end of the under cover (b) comes inside the bumper face - fron ...
Component
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCOMPONENT1. STARTER(1)Starter housing ASSY(9)Overrunning clutch(17)Sleeve bearing(2)Sleeve bearing(10)Internal gear ASSY(18)Starter cover ASSY(3)Shift lever(11)Shaft (4)Plate(12)Pinion gearTightening torque: N·m (kgf-m, ft-lb)(5)Seal rub ...